Jump to content

BMC

BMC Sub-forum

665 topics in this forum

  1. INJECTOR REMOVAL

    By NB Hopalong,   
    • 2 replies
    • 320 views

  2. Rear crankshaft oil seal 1500

    By Mikexx,
    • 5 replies
    • 1.1k views

  3. BMC 1.5 diesel rebuild

    By GBW,
    • 6 replies
    • 554 views

  4. Money saving tip

    By GBW,
    • 0 replies
    • 552 views

  5. BMC 1.8 ground wire

    By AndrewV,
    • 3 replies
    • 541 views

  6. Bmc 1.5 fly wheel housing

    By Karen karesh,
    • 6 replies
    • 433 views

  7. BMC 2.2 Intermittant blue smoke?

    By Quattrodave,
    • 4 replies
    • 572 views

  8. Anyone know what this is for?

    By GBW,
    • 17 replies
    • 1.1k views

  9. Ring gap

    By GBW,
    • 6 replies
    • 810 views

  10. BMC 1500 running rough on start up 1 2

    By Cheshire cat,
    • 48 replies
    • 1.9k views

  11. Engine Running Sensor 1 2

    By Quattrodave,
    • 30 replies
    • 1.2k views

  12. How would you interpret this?

    By wandering,   
    • 9 replies
    • 710 views

  13. BMC 1.5 stop lever.

    By GBW,
    • 7 replies
    • 438 views

  14. My experience of removing a Top-Hat

    By Mikexx,
    • 15 replies
    • 833 views

  15. Drive plate bolts BMC 1.5 1 2

    By StephenA,
    • 39 replies
    • 1.2k views

  16. BMC 1500 glow plugs

    By TimmyT,
    • 22 replies
    • 884 views

  17. 1.5 temperature sender / switch thread size

    By Mikexx,
    • 13 replies
    • 3k views

  18. Clanging sound when in gear at low revs

    By Mikexx,
    • 13 replies
    • 729 views

  19. BMC 1.5 Drive Belt - Help, I've chopped mine in half! 1 2

    By ionayes,
    • 31 replies
    • 1.4k views

  20. BMC 2.2 water pump

    By seasurveys,
    • 20 replies
    • 691 views

  21. Fire!

    By GBW,
    • 24 replies
    • 1.2k views

  22. BMC 1.5 Oil with a lot of fuel in it. 1 2 3 4 7

    By mtbvincent,
    • 166 replies
    • 9.7k views

  23. BMC 1.8 failure to start after tickover cut out 1 2 3

    By marksbrown,
    • 72 replies
    • 3.1k views

  24. Torquing the crank nut

    By David Mutch,
    • 22 replies
    • 901 views

  25. 3d printed timing tool

    By p6rob,
    • 9 replies
    • 1.3k views
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.