luggsy Posted June 14, 2017 Report Share Posted June 14, 2017 Hi am I right in thinking I can connect a 12v pc fan to my Mppt controller on the load connection? As in the warm weather and when the oven is on it can get quite warm in the cupboard where the inverter is , I was going to put a inline fuse and switch so I can turn it on/off when required thanks in advance Link to comment Share on other sites More sharing options...
Alan de Enfield Posted June 14, 2017 Report Share Posted June 14, 2017 20 minutes ago, luggsy said: Hi am I right in thinking I can connect a 12v pc fan to my Mppt controller on the load connection? As in the warm weather and when the oven is on it can get quite warm in the cupboard where the inverter is , I was going to put a inline fuse and switch so I can turn it on/off when required thanks in advance I cannot see a problem - I wired in a cigarette lighter socket & ran my VHF radio from the 'load connection' on the MPPT Link to comment Share on other sites More sharing options...
matty40s Posted June 14, 2017 Report Share Posted June 14, 2017 if you have a Tracer or similar unit, the Load circuit is probably the most unused piece of the kit as far as narrrowboat installations go. Ones I have seen in action powered external nightlights for a set period, or a couple of light fittings in the main cabin to make it look like someone was on board. The fans take so little volrage, why don't you wire quite a few fans in the same circuit, perhaps one behind bath or shower tray, one behind fridge etc, to reduce heat or damp at the same time. Link to comment Share on other sites More sharing options...
KenM Posted June 15, 2017 Report Share Posted June 15, 2017 10 hours ago, matty40s said: if you have a Tracer or similar unit, the Load circuit is probably the most unused piece of the kit as far as narrrowboat installations go. Ones I have seen in action powered external nightlights for a set period, or a couple of light fittings in the main cabin to make it look like someone was on board Am I misunderstanding my Tracer? I understood the Load connection was direct from the panels. How can it power a night light? Link to comment Share on other sites More sharing options...
nicknorman Posted June 15, 2017 Report Share Posted June 15, 2017 1 minute ago, KenM said: Am I misunderstanding my Tracer? I understood the Load connection was direct from the panels. How can it power a night light? No it is not direct from the panels. Apart from anything else, panel voltage is far too variable to be of any use. The general idea is that it is for, eg, a streetlight. The Tracer controls when it comes on and for how long, and will cut it off in the event of low battery state. Link to comment Share on other sites More sharing options...
Alan de Enfield Posted June 15, 2017 Report Share Posted June 15, 2017 13 minutes ago, KenM said: Am I misunderstanding my Tracer? I understood the Load connection was direct from the panels. How can it power a night light? You will need to add 'Lunar Panels' to your system - gives you a full 24/7 output. Link to comment Share on other sites More sharing options...
ditchcrawler Posted June 15, 2017 Report Share Posted June 15, 2017 1 hour ago, Alan de Enfield said: You will need to add 'Lunar Panels' to your system - gives you a full 24/7 output. Or moor under street lights Link to comment Share on other sites More sharing options...
Alan de Enfield Posted June 15, 2017 Report Share Posted June 15, 2017 1 hour ago, ditchcrawler said: Or moor under street lights But you only get the benefit of using street light if you have paid council tax - if you don't pay CT then the light produced is blocked from being used on solar / lunar panels. 2 Link to comment Share on other sites More sharing options...
Chewbacka Posted June 15, 2017 Report Share Posted June 15, 2017 8 hours ago, KenM said: Am I misunderstanding my Tracer? I understood the Load connection was direct from the panels. How can it power a night light? These controllers are designed to work a street light, and - for example mine - knows when it is dark by the panel voltage, and it can be programmed to turn on a light at dusk for a few hours and again before dawn. Quite flexible, but for me I never use the load output. Link to comment Share on other sites More sharing options...
Bewildered Posted June 16, 2017 Report Share Posted June 16, 2017 On 15 June 2017 at 08:37, KenM said: Am I misunderstanding my Tracer? I understood the Load connection was direct from the panels. How can it power a night light? Most Solar controllers aren't designed specifically for marine use, they are primarily designed for off grid living and in this situation you are likley to have more things you may want to run off the controllers timed load circuit. This circuit uses regulated voltage battery power even during the day when panel voltages can be high. During the day the panels will charge the batteries and run the load if connected at 12v even if the panels are producing more, if the light level (and hence panel voltage) drops the batteries make up the shortfall in voltage to keep a stable 12v. Obviously at night it is all battery power used until the batteries get low in which case the circuit should switch of to protect the battery from discharging too low. on boats the circuit is rarely used unless you want timed lights for security reasons. If you just want a switched circuit it's easier to just pick up 12v from the battery and have a fuse in line than to mess about programming the Tracer output. But you can use it if you want to. Link to comment Share on other sites More sharing options...
smileypete Posted June 16, 2017 Report Share Posted June 16, 2017 (edited) If the load output can be set to 24/7 it could be used to remotely warn of over discharging batts, by charging a cheap/surplus PAYG phone via a 12v to usb charger. All it needs is to set the phone to text when charging power is removed for some period of time, this can be done using the 'E-Robot' app on Play store. The charging circuit could also be interrupted by a door entry switch or relay from the engine starter, giving some sort of security function too. Edited June 16, 2017 by smileypete Link to comment Share on other sites More sharing options...
Featured Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now