Jump to content
Strawberry Orange Banana Lime Leaf Slate Sky Blueberry Grape Watermelon Chocolate Marble
Strawberry Orange Banana Lime Leaf Slate Sky Blueberry Grape Watermelon Chocolate Marble
Sign in to follow this  
jacky

As 2 gear and throtle control

Featured Posts

Do you really have a scaffolding pole as a gear lever or is than an exaggeration? Is the tootle a typo for throttle?

 

What engine do you have and where is it located on your boat?

Share this post


Link to post
Share on other sites
34 minutes ago, jacky said:

My gear control is a scaffolding  pole and tootle is a motorbike cable to a rachet what alternatives could I use ?

A broomstick and a piece of string? 

 

 

Share this post


Link to post
Share on other sites

I really have scafolding pole, the engine is situated in a vintage narroboat that has engine room at the very back, when she is in forwards gear I can't reach the pole to get her back into neutral,  the engine is an armstrong , i am looking for ideas so that I can actually use my boat, I no very little about engines 

Share this post


Link to post
Share on other sites

Please send a photograph to prevent the idiots on here trying to get a laugh at your expense.

I am guessing that you have a Armstrong air cooled  engine and gearbox with the gear-stick in the middle of the rear deck with a little lever throttle with a cable to the engine?

 

If so it is difficult to change it all, for say, a Morse single lever control lever like modern boats. Also guessing its a Springer boat?

Edited by Tracy D'arth

Share this post


Link to post
Share on other sites

sticks and string is just fine - don't be ashamed of your arrangements.

 

Bizzard would use a tin can and a piece of string but you need an engine room artificer to listen at the other end.

Share this post


Link to post
Share on other sites

I think it must be an old fashioned mechanical box so I fear it will have to be big leavers. You may be able to fit a big remote lever closer to where you stand and link it to the existing one with a stout bar or rod.

 

I am sure you could use a simple throttle control and push pull cable or rig up a speed wheel but if the ratchet (I doubt it is a ratchet) works and you can get at it why spend money.

Share this post


Link to post
Share on other sites

It is a rachet , and thats is usable I have been told I carnt use a more controller because there is no spring strong enough for a parsons box . I will take photo tomorrow and post it 

Share this post


Link to post
Share on other sites
Just now, jacky said:

It is a rachet , and thats is usable I have been told I carnt use a more controller because there is no spring strong enough for a parsons box . I will take photo tomorrow and post it 

 

I agree that you can't use a modern (Morse) control for the gear change but if you wanted to I am sure you could use a single function one for the throttle.

 

Its not a question of a spring, its a question of a cable strong enough and getting the remote end with a long enough lever to allow you to operate it.

Share this post


Link to post
Share on other sites

If the engine is the marine version of the AS then it should have a lever attached to a bracket fastened to the fan shroud. This can be operated with a single lever and cable. If the engine is an industrial conversion then it probably has a simple plunger working on a spring  connected to the governor inside the timing cover on the front of the engine. This needs a horizontal push mechanism (the spring will return it to the off position). The operating system for the gearbox depends entirely on the gearbox fitted. Have a word with Daniel(stagedamager on here) who is my son and has what is probably the largest known stock of AS parts and is based at Langley Mill Boatyard at the top of the Erewash. Regards, Hugh.

  • Greenie 1

Share this post


Link to post
Share on other sites
Quote

 

The Petter pd2 had a parsons gearbox and it was operated by a wheel from the cabin. I can’t remember how this arrangement moved the lever at the gearbox but someone will probably be able to explain it or have a photo.

its the big white wheel on the right the other being the speed wheel.

141B442E-3569-408D-871A-14749A9DDB16.jpeg

Edited by Dav and Pen
Content

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.