Jump to content

1agos

Member
  • Posts

    254
  • Joined

  • Last visited

Everything posted by 1agos

  1. I have called out RCR 3 times in six years. Engine alternator replaced - foc parts and labour Broken engine mounting they replaced a pair - foc parts and labour and a throttle cable I had to pay for. I am impressed with their service so far.
  2. This post cannot be displayed because it is in a forum which requires at least 10 posts to view.
  3. This post cannot be displayed because it is in a forum which requires at least 10 posts to view.
  4. I run the engine as little as possible when moored as the solar panels don't put anything in to the battery bank when the alternator is doing its thing.
  5. Thanks Ray T I'll get in contact..
  6. Can anyone recommend a competent engineer who can swap out my mechanical gearbox and fit a PRM .which will need an oil cooler fitted too. Boat is in Stone Staffordshire. thanks in advance.
  7. When the second mate asks 'what are you doing' on those occasions I am aiming off boat. I always reply with 'Saving the loo'
  8. I was once blinded by a boat with what looked like two car spot lights aimed dead ahead bolted to his roof . I had spots before my eyes after we passed in Braunston tunnel.
  9. This post cannot be displayed because it is in a forum which requires at least 10 posts to view.
  10. We just came off the LLangollen today (IWA volunteers worked all the Hurleston locks for us) ... there are absolutely nothing to worry about, The most scenic canal we have done todate , plenty of good moorings , there was never more than one boat in front of us waiting at locks but we were in a convoy of 5 going over the aqueduct to Trevor. There are a lot of hire boats but they were never a problem. Second time we have done this canal and can't wait to do it again.
  11. This post cannot be displayed because it is in a forum which requires at least 10 posts to view.
  12. We have a Vetus dripless stern gland on our boat, but doesn't look anything like your picture. Someone will be along to help I'm sure.
  13. Doesn't look to be tapered, I'll fit without as suggested. Thanks for your replies guys.
  14. I thought that maybe the case as maybe the sensor is earthed via the threads as it is a single pole unit.
  15. When fitting a new temp sensor to my Vetus engine, do I need to use thread locker/sealant. Thanks in advance.
  16. 1agos

    Sofa bed

    Glad you have got sorted
  17. This post cannot be displayed because it is in a forum which requires at least 10 posts to view.
  18. The double lip seal will need replacing.(common fault on these) . From vetus this is about £90 ( they don't sell the seals separately but with the brass housing .....I haven't found a supplier for the seals alone). Easy to do in the water but less stressful on the bank side.
  19. What do you guys think about adding Hydrogen peroxide to the water tank to clean it after a winters lay off. 1 to 100 litres. Have spoken to a water expert (20 years in the north american water industry) who says this is the best way to go and add 500ml to a tankful bi monthly I only remember this stuff turning my mums hair yellow.
  20. I you buy Peek get it from Amazon Cheaper than in chandlers.
  21. If you are going through Atherstone at any time .www.coxautomotive.co.uk/ do a 24 hour turnaround service. I had mine repaired last year they are a short walk from the canal.
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.