Genny/solar charging mystery

[jenevers]

The only things “on” are the lights on the MPPTs and the MICC. 

[Dr Bob]

24 minutes ago, jenevers said:

 

 

No no

All switches on the board are off

Haven’t got an Eberspacher

How?

You haven't wired up your EcoFan wrong have you?

[WotEver]

24 minutes ago, jenevers said:

How?

Firstly by confirming the drain. Then by following the wires from the Batteries you’d see which one is carrying the current and you’d soon find the culprit. 

[nicknorman]

24 minutes ago, jenevers said:

 

How?

Well for starters it would tell you whether it was a real 2.9A or some offset error in the MICC. Then you just follow the wires that have the current until it leads to the device causing the drain.  

[WotEver]

15 minutes ago, jenevers said:

The only things “on” are the lights on the MPPTs and the MICC. 

Something’s on because it’s drawing 3A. Either that or there’s a fault in the wiring (damp tracking to hull). 

[jenevers]

On 24/11/2017 at 09:58, WotEver said:

Firstly by confirming the drain. Then by following the wires from the Batteries you’d see which one is carrying the current and you’d soon find the culprit. 

 

On 24/11/2017 at 09:59, nicknorman said:

Well for starters it would tell you whether it was a real 2.9A or some offset error in the MICC. Then you just follow the wires that have the current until it leads to the device causing the drain.  

Must get one!

[cereal tiller]

On 24/11/2017 at 08:58, Dr Bob said:

You haven't wired up your EcoFan wrong have you?

There is a Wiring Configuration on the Ecofan which causes solar Phenomena and Tremors which register on the Baron Von Richthoven Scale

It is marked on the Base, a little Red Cross I think.

Edited November 25, 2017 by cereal tiller

[jenevers]

The mystery deepens! On the MICC display is the info “ERROR CODE RELAY ON”. Strange, as that’s not a listed code in the manual.

Any ideas what “RELAY ON” means?

When I press the Ah time button I get “13.3v -3.2A” But next morning the display reads “ERROR CODE RELAY ON” again.