Jump to content

Lister STW3 thermostat housing joint


Featured Posts

Hi all,
I need to get a new joint for my STW3 thermostat housing. Part number 202-91080. Its the gasket or seal that goes between these two parts of the housing:




I am fairly sure I can make one from Neoprene, cork or paper, but the old material has decayed to the point that I cannot even identify what it was made of!
Anyone know?



Edited by nbbranwell
Link to comment
Share on other sites

If my memory serves me I think that they were a made of a card type gasket material a couple of mm thick. Mind you I don't think it make to much difference whatever you use.

Link to comment
Share on other sites

Wheaty packets, soaked in oil, work fine, but you can buy 300 mm square sheets of gasket material on line.  Klingerit is a good name. 1 mm thick is likely to be plenty.  2 mm thick  gasket material is like cutting lino.



Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.