Teddy Bear

Sorry for not relying sooner but my Internet connection hasnt been great. Thanks everyone for your responses, I will read them all again thourally after this update. My battery light has started flashing, the beeping is still their, I have checked for damaged cable but cannot find anything, batteries have been recently changed so should be like new.

I suspect the start / stop sounder. Within the last hour a constant sound is coming from the instrument panel it sounds like a high pitched Morse code, I've checked for loose conections but can't find anything wrong. I have placed tape over the sounder to mufflel the sound, but what is causing it. Any ideas please.

Hi, My rudder and tiller doesn't line through straight. Is this an easy job to correct, I have the boat on a hard standing until Thursday so would like to put it right before she goes back in the water.

Does anybody know of a reputable marine electrician in or around the Lymm area.

lol, yeah know exactly what you mean the loo stank of sage & onion stuffing, but apart from that loved the boat...

Thanks for your comments

Has anyone any ideas, where I may find a latch like the one below.

Nice choice of colours, have a look at this.

We got our sailaway from LMBS towards the end of last year and they were great no problems what so ever, Chris was very helpful and the lads working on the boats were friendly, We would definately recommend them.

I'm sure everyone will be able to help me with this. Most boats i've seen have a pre-finished dimple effect, brown sheet materal for their engine room floors. Can anyone tell me what its called?

As I poninted out in my original post 6mm cable doesn't fit the switches either. Do you have your pump switched, if so how? As for fitting a cable thats too large, I disagree. But then again I'd rather be over than under sized.

Please explain why relays are nonsense and why 10 & 6mm cable is introducing problems?

I’ve run a 10mm tri-rated cable 12v DC supply to a water pump but need a switch midway to turn it on or off, problem is the terminals on switches aren’t large enough. How have other people overcome this? The same problem will arise when I come to do the lighting switches (6mm)

Thanks everyone.

In laymans terms can someone explain, electricly what a shunt is and why it is used...