jenevers Posted May 2, 2015 Report Share Posted May 2, 2015 Each of the screws above the levers on my fuel pump leaks slightly. Am I in order to tighten up these screws, or are they "calibrated" in their current positions? Link to comment Share on other sites More sharing options...
steamraiser2 Posted May 2, 2015 Report Share Posted May 2, 2015 OK to tighten them. Minor leaks from this area are not uncommon. Nothing to worry about. Link to comment Share on other sites More sharing options...
jenevers Posted May 2, 2015 Author Report Share Posted May 2, 2015 OK to tighten them. Minor leaks from this area are not uncommon. Nothing to worry about. Thanks Didn't want to adjust anything that was "factory set". Link to comment Share on other sites More sharing options...
Timleech Posted May 2, 2015 Report Share Posted May 2, 2015 Thanks Didn't want to adjust anything that was "factory set". There might be a little bit of lead puched into a hole adjacent to the screw head, as a sort of locking device. If it's present, just punch it in again with a flat ended punch. Some, not all, of those screws have a knurled edge to the head for this to grip into. Tim. Link to comment Share on other sites More sharing options...
jenevers Posted May 2, 2015 Author Report Share Posted May 2, 2015 There might be a little bit of lead puched into a hole adjacent to the screw head, as a sort of locking device. If it's present, just punch it in again with a flat ended punch. Some, not all, of those screws have a knurled edge to the head for this to grip into. Tim. Thanks but there aren't any leaded holes on my pump. Good idea though. Was that on early or late pumps? Link to comment Share on other sites More sharing options...
Featured Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now