beta marine b3kr1

[shaun.riley]

hi

i have a beta marine B3KR1 engine do any of you know what heater glow plugs i need

[Canal Shop Man]

hi

i have a beta marine B3KR1 engine do any of you know what heater glow plugs i need

Have you looked to see what it says on the existing ones? Either on the white ceramic bit or on one hexagon face. What you already have is a good starting point

[Cafnod]

Are you sure the glow plugs are at fault? If they are a multimeter will show them as open circuit. You could do worse than go to a DECENT motor factors and put them on the counter and say four of these please.

[shaun.riley]

all it say on the hex bit is 8j and nothing else i think this is the fault because the engine used to start with me using them then now it wont and there is power going to the plugs so i am thinking it is the plugs at fault

however i can start the engine by putting a flame down the air intake and the engine fires and runs normal

Edited June 26, 2006 by shaun.riley

[bottle]

Hi Shaun

 

Here is Beta Marine website it will not give you the answer directly but gives ways of contacting them, I expect they will know the right ones.

 

You say there is no power going to the plugs have you checked all the wiring and connections right back to the point of supply.

Edited June 26, 2006 by bottle

[shaun.riley]

Hi Shaun

 

Here is Beta Marine website it will not give you the answer directly but gives ways of contacting them, I expect they will know the right ones.

 

You say there is no power going to the plugs have you checked all the wiring and connections right back to the point of supply.

 

 

i said there is power going to the plugs.

[bottle]

 

 

i said there is power going to the plugs.

 

Sorry Shaun I misread it.

[shaun.riley]

thank you all for your help i have now found some at a company called

jennings in netherton the guy there is well up on his trade very knowledgible