Small Mono Mixer Tap (Cloakroom Type??)

[Richard10002]

Our shower room basin tap is fitted such that it cannot be opened to its' full power when in the centre position, (equal hot and cold supply), due to the trim on the woodwork behind/above it.

 

I dont want to mess with the woodwork, so have been looking at taps that aren't as tall.... but the ones that will fit and open fully dont have quite the reach over the basin.

 

Existing tap is 11cm tall, with a reach of 11cm from the centre of its' fitting to the centre of the outlet spout. I think I have about 9.8cm in height, but the way these things are measured, I may have a bit more.

 

There are taps that are 10cm tall, (which would fit fine), but the max reach I can find is about 9.3cm and, whilst 1.7cm may not seem much, I think it will make things a bit difficult. I could spend my twenty to thirty quid, go through the faff of fitting, to see how it would work, (and it might be fine), but no sense in reinventing the wheel if someone here has been through the same process.... or is better at googling than me

 

Here are the three taps that I think would work from a height point of view, (10cm or less), but maybe not from a reach point of view, (ideally I would like 11cm reach):

 

https://adexa.co.uk/Basin-Mixer-Tap-Single-lever-Chrome-Adexa-10128000?language=en&currency=GBP&gclid=CjwKCAjwpKCDBhBPEiwAFgBzj1rUfmYFDER-43COJ0K2qk68fERfmknd6B-up5-dZPV-a61VTHQxLhoCOQcQAvD_BwE

 

https://victoriaplum.com/browse/basin-taps?csi=PULTAP01&ds_kid=92700059867490532&gclid=CjwKCAjwjbCDBhAwEiwAiudByxv9LJLcHIPj0suZgPHUNc6MJGLUu-_pEkuEd4RtRKiZDncQNdYZvRoCvMIQAvD_BwE&gclsrc=aw.ds

 

https://www.heatandplumb.com/acatalog/niagara-conway-tap-9112

 

any contributions welcomed, but I wont be moving the basin away from the wall