Search the Community

Can anyone advise please? The kubota v1903 engine won't start. When you turn the ignition the starter relay at rear of ignition panel makes a noisy whining sound, doesn't sound good. Red Lights on panel intermittent on off as you turn key. On turning key to start there is nothing but the whiring noise as you then turn the key into off position. Batteries are all OK. Voltage checked. What i can see, doesn't seem to be any lose wires. It just suddenly stopped working, there been no faults up till it stopped working. Starter has been working fine e every time. Anyone know what the fault is? Could it be the relay be the fault or something else. Where can I get hold very quickly of the relay unit? Relay info... Denso 12v starter timer relay 061700 - 3770. Thanks

For a while now, I've noticed it takes longer and longer to get the engine going on my narrowboat. Today I gave up as I felt I was just running the battery down. Once I get it going and run the engine for a while, if I turn it off and try again shortly after it starts first time. So, it feels like a problem getting warmed up in the first place, which would indicate an issue with the pre-ignition starter, wouldn't it? I've read a few similar threads, but nothing that describes quite the same problem, so grateful for any advice.

Hi everyone, im hoping somone might be able to help. ive recently bought a narrowboat and have just changed the gas bottles after running out. the oven and hot water are working fine since changing over the gas but the fridge (a SIBIR) will not turn on. I’ve been trying for a few days now but still no luck. The fridge was working perfectly on gas until the bottle ran out. i have been pressing and holding down the gas knob at the bottom of the fridge (far right in photo) and then pressing the ignition button (left in photo). Occasionsly I get a spark but the pilot does not stay on. I have tried adjusting the middle dial to every setting but doubt this would make any difference bevause that sets the fridge temperature when turned on. Any advice would be appreciated. Thanks

Hello! I have a couple of engine questions! Everything I know about engines I've learned when something has gone awry with my engine over 5 years of boating. I must have been very lucky as I'm still quite ignorant. I nearly killed my starter battery by leaving the key in the IGN position when I turned off the engine yesterday. I only noticed because the dedicated solar charge controller for the starter was making a ticking noise. I jump started the engine and fortunately the battery is now OK. Which leads me on to my first questions: 1) Should there be a deafening beeping as soon as the key is in the IGN position and the engine's not running? If so, is it possible that something has come unplugged, or is there a missing component? 2) What is actually draining the battery when it's in this position? This is the second time this has happened, last time I wasn't so lucky and the starter battery was shot. Luckily though, I had a semi-dead leisure battery that I managed to bring back to life. It now always reads 13V. This first instance happened only a few weeks into owning this boat, so for the most part I've been using said leisure battery as a starter. The engine always struggles to turn on - I warm the plugs for a good 20 seconds, try to start her in neutral with the clutch, then try giving some revs, then engage the engine, give it some revs, then it gets going - maybe none of this helps, it just needs a lot of encouraging. 3) If my engine struggles to turn on, would it likely start better with a made-for-purpose starter battery? I also have an issue with the fuel line right at the tank - actually I just need to get the tank cleaned. This means that the engine won't run or start unless it's on high revs (no RPM gauge so can't say exact how high) and cuts out in neutral/low revs even when warm. Is this more likely the culprit? (I still had the same issue before this problem developed). I'll be very grateful for your input before I roll up my sleeves and get oily/diesely.

Hi The five year old boat I recently bought has a Spinflo Caprice III cooker. The 'electronic' ignition on the hob works fine but not on the grill or oven. There doesn't appear to be a spark. I wondered if anyone had any experience of this problem and could give me a clue as to how easy it might be to repair. I'm assuming I might need to replace some parts. Regards, Ian