Hydro-Steer

Hi Maffi!

 

Been looking at Hydro Steer drawings.

 

What does the Green cable from the hydraulic pump do? What pump is it?

 

I take it the forward and reverse circuit would be the same but attached to the power/gear lever? This could be a smaller powered setup... have you got any ideas what to use?

 

Do you have a parts list?

 

Been looking at the other drawings..... what is the Bendix motor and solenoid used for?

 

Good interesting stuff... many thanks!

Hi Maffi!

 

Been looking at Hydro Steer drawings.

 

What does the Green cable from the hydraulic pump do? What pump is it?

 

I take it the forward and reverse circuit would be the same but attached to the power/gear lever? This could be a smaller powered setup... have you got any ideas what to use?

 

Do you have a parts list?

 

Been looking at the other drawings..... what is the Bendix motor and solenoid used for?

 

Good interesting stuff... many thanks!

 

The two black lines are hydraulic feeds/returns to each end of the ram the green line is a return line should the ram run to the end and operate the poppet valve.

 

The forward and reverse could well be on the throttle there was a thread on this last year. It could be on the control panel.

 

The 'Bendix' is a type of starter motor, the pinion is thrown forward to engage only after the motor starts to turn.

 

The solenoid is a blow up of the solenoid on the other drawing, on the other type the solenoid engages the pinion before the motor starts to turn hence the name 'Pre-Engage'.

 

 

Parts List

1 3 position switch

1 Hydraulic Pump

1 Hyd Ram

2 Relays

Hyd Pipe as required

 

Best I can do, sorry.