Captain Nitromors

sounds easy but not sure were the componants are that it mentions as im pretty thick were engines are concerned

1500 bmc was running belting with no problem then sunday morning just turns over now till battery goes flat

Hi my bmc engine wont start, i think it was due to running out of diesel, however i dipped my stick in tank and was about 4 inch up the stick, is this a level that is empty? Anyway i put 30 quids worth of deisel back in and still wont start is this due to air in the system now as i have no idea how to bleed it

no joy still hot water cutting off ?

thanks i will try that method later to see if works ta

rinnai water heater it is

Hi can anyone tell me why my water boiler runs hot water for about ten second then cuts out to cold then fires up splutters then cold again, i have filled the tank with water so enough water getting to it, really annoying any help would be great,

Hello just wondered if anyone had any ideas on how i can fit a shower into my springer toilet room, not a lot of space but with the v bottom most of what i have is sloping with about 6 inch streight at the bottom to play with, if i level the floor off im losing hight and struggle to stand up .

Hello im not very technical minded on electrics but i want a few lights on my ceiling, i am just about to tongue and groove it and want about four going down the middle, how do i wire these, i just want them on a switch at side of door so they all come on at once, preferably be some low wattage to save on battery power.

The other day i accidentley let the water tank run empty, the water obviousley stopped coming out of the tap, i filled the tank up switched tap on and no water comes out now, just a gurgling and a very slow trickle this happens when either the hot or cold tap is on. The pump makes noise but for some reason just a trickle flow out the taps? anyone any advice on whats wrong thanks

were do i get sudo flex from and how much is it ?

i get some tommorrow and rescue the existing battens i not tonge and grooved yet, one or two have come loose in the area i have done but looks ok and still in a curved shape, i put one in middle, one at either side and one at either side of the centre one so have 5 altogether, will need to rip off wot i stuck with the other stuff, dont want all the lot coming loose.

Think i need to prop it up as i go and try some grip fill

Hi what is the best thing to use to stick battens to the roof ready for tongue and groove?,i have used some liquidy nails type stuff but has not held too good

Think its a maplins adaptor this weekend thankyou