mike_p

should have got a pic, shared the fun with the rest of us

looks quite exciting for boating, saw afew boats go though chertsey lock yesterday afternoon. not a bad flow on, only plastic palaces though, no ditch crawlers one nearly hit the bridge downstream, but just missed (disapointed the lockies as they had a moan at him for speeding)

thames looks ok in staines. sat eating dinner looking over river. no boats moving though

if you can get a replacement relatively cheap id go with that option. inverters when they go bang have a nasty habit of blowing most components inside them. they can be repaired but it usually means replacing 99% of components an hoping the circuit board itself doesnt have big holes in it

http://www.force4.co.uk/ProductDetails/mcs...06-9964a9c41622 spotted these while looking for other things, quite cheap an looks good for safety equipment too

b & q advertise them on there website, but ive never seen one in the shops. always afew on ebay if your a fan of online ordering

anyone else coming along? heres my boats ready to go

main trips an slipway at tapton lock, lockoford lane, chesterfield. *boat trips *canoe sessions *launch your own boat/canoe (insurance docs required) *visitors centre Enquiries to tapton lock visitors centre 01246 551035 anyone with a trailerable boat be good to see them there, i'll be there with mine an a couple model boats too.

thought id said it quiet enough not to be noticed. there nearly same just dont float aswell. no volvo in sight here, nice british built rover

thanks, have got that pdf, but it refers to using the templates, that dont seem to be available without buyin a new loo. its fitting into a caravan, so the holes got to be right first time, scary times chopping big lumps out so want to get it right

i know some people have these fitted into boats. just wondering how they have mounted them, do you put them on a shelf to raise them up? an does anyone have the templates for the hole for the cassette, ive got hold one but no templates, an doesnt look much if any room for error on the cut out

i usually find when cycling the anto motorbike things they fit only serve to stop cyclist an people that are ment to be there. the motorbikes are to low or just make there own access.

oops ................. i think i drilled that hole abit deep

doh, going ot go an do my lines now i must open eyes an read forum i must op...........

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?Vie...=tab%3DWatching saw this on ebay very cheap, but i think i can see why