Jump to content

Featured Posts

My day hire boat has 2 smallish lockers, one on each side, right at the stern. The covers are currently painted plywood. The paint is peeling and the ply is starting to open up, they need replacing.

 

I'm torn between using 3mm steel or 12/18mm marine ply. I'd paint the steel but varnish the ply, should look nice. There's a curve to cut on each locker cover. I could probably shape the ply myself but the steel would be beyond me.

 

What do you think the best option would be?

Link to post
Share on other sites

buffalo board but you don't need a full sheet - try a trailer manufacturer for some offcuts - they use it for the deck of the trailer.

seal the edges with epoxy resin - that is where the rot starts, even on buffalo board (hexagrip is the same thing).


You could also trim the edge with aluminium or hard wood angle held on with silicone sealant. Protects the end grain from damage and then becoming absorbent.

what I did - it's good

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.