Rocker shaft Banjo

[Maudesmaster]

Looking for a banjo 5/8” bolt size 1/4” pipe hole looking to purchase new or used cannot find in www 

Making new pipe up as original when bought engine had a soldered sleeve which j have re soldered twice 

I have the pipe and have flared end 

I don’t want to take original off and reuse until new pipe stood the test of time 

thank you in advance 

[Split Pin]

Search

Stafford Vehicle components

Fuel pump supplies 

you will find a variety of sizes

 

Steven

 

[David Mack]

Not sure I quite understand what you are after. Are you looking for a banjo which you can screw that pipe into the end of, and which will then be bolted down to the engine with a 5/8" banjo bolt (and copper/dowty washers) you already have? If so you will need to identify what type of thread you have on the nut on that pipe. If this is a British engine with imperial threads it could be 1/4" UNF, or 1/8" bsp.

[Split Pin]

There is a banjo on the other end of the pipe. That is what he is looking for so that he can make up a new pipe

 

[dmr]

I needed a banjo a couple of years ago and they are not that easy to find.   There are a few on eBay and these mostly have a BSP thread so there is no need to solder, just make up a pipe with suitable unions at both ends.

[stablemabel]

Have you tried Walsh Engineering theyre in Irlam near Manchester.They do a lot of Gardener stuff