CLAN1 Posted March 7, 2021 Report Share Posted March 7, 2021 Hi, any idea what pressure an accumulator should be??? Cheers ? Link to comment Share on other sites More sharing options...
frangar Posted March 7, 2021 Report Share Posted March 7, 2021 Couple of PSI below the pump cut in is a good starting place....somewhere around 7-9 psi...set it with water pump off and taps open. Link to comment Share on other sites More sharing options...
CLAN1 Posted March 7, 2021 Author Report Share Posted March 7, 2021 Thank you ? Link to comment Share on other sites More sharing options...
Tony Brooks Posted March 7, 2021 Report Share Posted March 7, 2021 or about half the pump cut out pressure that is written on the pump is near enough to what @frangar said and may be easier. Link to comment Share on other sites More sharing options...
ditchcrawler Posted March 7, 2021 Report Share Posted March 7, 2021 54 minutes ago, frangar said: Couple of PSI below the pump cut in is a good starting place....somewhere around 7-9 psi...set it with water pump off and taps open. As most of the pumps seem to be 2 Bar + I would say7-9 is a bit low, maybe 15 would be better Link to comment Share on other sites More sharing options...
frangar Posted March 7, 2021 Report Share Posted March 7, 2021 (edited) 13 minutes ago, ditchcrawler said: As most of the pumps seem to be 2 Bar + I would say7-9 is a bit low, maybe 15 would be better Cut in of my jabsco parmax 4 is 10 psi. That’s with cut out of 25psi. Edited March 7, 2021 by frangar Link to comment Share on other sites More sharing options...
nicknorman Posted March 7, 2021 Report Share Posted March 7, 2021 3 hours ago, CLAN1 said: Hi, any idea what pressure an accumulator should be??? Cheers ? Don’t forget that in order to check and adjust the accumulator air pressure, the water side has to be depressurised (pump off, taps open). Link to comment Share on other sites More sharing options...
frangar Posted March 7, 2021 Report Share Posted March 7, 2021 11 minutes ago, nicknorman said: Don’t forget that in order to check and adjust the accumulator air pressure, the water side has to be depressurised (pump off, taps open). As I said in the 2nd post down.....? Link to comment Share on other sites More sharing options...
ditchcrawler Posted March 7, 2021 Report Share Posted March 7, 2021 3 hours ago, frangar said: Cut in of my jabsco parmax 4 is 10 psi. That’s with cut out of 25psi. And that's the problem, we don't know what the OP has, I just looked at Surflo spec. Link to comment Share on other sites More sharing options...
Featured Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now