Jump to content

Remove ejector JS3M


Nds123

Featured Posts

Use the compression pressure to loosen them. 

Loosen, but do not remove the injector  securing nuts.  Set the speed control to STOP and the decompressors to the running position then turn the engine over by starter motor.  Alternatively rotate by hand with decompressors in  then drop one of the decompressors out.

If that does not do it, get a slide hammer on them after removing the setting cap.

 

 

If you feel really brave, loosen the injector securing nuts a little and start the engine.  Let it run till all the injectors are loose. Not recommended ?

N

Link to comment
Share on other sites

Before you do, check where the leak is coming from. If the injector cap is loose it's OK to tighten it up. The other likely source is the spill rail where it is screwed onto the injector. 

 

Richard

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.