Lister Petter LPWS3 tickover adjustment

[PaulG]

The tickover is a bit slow on my Lister Petter LPWS3, and it stalls occasionally when going into neutral.
It's a standard Morse control for revs and gears.

Not sure whether I should be adjusting the Morse cable or the governor.

Can anyone tell be how to adjust it?

Thanks in advance.
PAul
 

 

[RLWP]

4 minutes ago, PaulG said:

The tickover is a bit slow on my Lister Petter LPWS3, and it stalls occasionally when going into neutral.
It's a standard Morse control for revs and gears.

Not sure whether I should be adjusting the Morse cable or the governor.

Can anyone tell be how to adjust it?

Thanks in advance.
PAul
 

 

Easiest would be the threaded stop screw on the engine

 

Richard

Edited May 13, 2019 by RLWP

[PaulG]

5 minutes ago, RLWP said:

Easiest would be the threaded stop screw on the engine

 

Richard

I'm sure that you're right, Richard.

If only I knew where to find it!
I had a quick look at the weekend and there were to be a lot of screws, many of which appeared to be the threaded variety.

Any chance you could be a bit more specific so that an ignoramus like me can adjust the right one (for a change)?

?
 

[RLWP]

I'll find an engine and take a picture

[PaulG]

20 minutes ago, RLWP said:

I'll find an engine and take a picture

Many thanks Richard!

[Ray T]

This may help as well as the photo's.

[PaulG]

Many thanks Ray,

Much appreciated!

[Ray T]

4 hours ago, PaulG said:

Many thanks Ray,

Much appreciated!

Paul, you have a pm.