huntergatherer

Thanks all for the advice I’m on the River Stort so I don’t think the restrictions that apply on the K n A will apply

I guess that will be the next step, I just wondered if any of the forum members perhaps used there boat in a similar manner and knew the answer .....

I’m hoping to use local spots on the river stort writhing 5 miles of my home mooring

Hello all i am going to be moving my boat to a club mooring on the river Stort soon. I am hoping to take my boat off the mooring and to visit locat spots where the fishing is better a few days each week. Most of these spots are frequented by constant cruisers boats and consequently attract the attention of mooring wardens, given that I have got a local home mooring and will only be staying for short periods am I allowed to revisit these spots a number of times throughout the year ?

Hello all I have a Thornetcroft T155 engine fitted to my boat, I gather it is a Mitsubishi engine, would anyone know the model, as I need to get some spares Regards Gary

Hello all Just installing my Morco, is there a specific height from the top of the Morco to the ceiling as I cannot seem to find it in the manual Thanks .-)

Hello all thanks for the advice Would someone be kind enough to post a simple diagram as I am not sure where abouts in the circuit I can fit the valve Does it have to be next to the calorifier .... Appoligise for being thick )

Thanks for the advice all .-)

Thanks for the advice all Bimble panels and controller it is .....

Hello all Any recommendations for a 12 volt battery charger around £500 I will be using a honda eu20i generator to run it and charging 1 x 110ah and 2 x 220 ah This one on ebay has caught my eye STERLING 'ULTIMATE' BATTERY CHARGER 'ProChargeU' 12v 60amp ? £440 delivered on ebay .....

Hello all I have got a £500 budget for my solar panels/ controller I will be running a 12 volt fridge a few lights on the nights I am not working and occasionally a 12 volt tv when I can get a signal Batteries will probably be 110 ah starter 2 x 220 domestic Stirling battery regulator 60 ah stirling charger Any recommendations ...... Thank you ☺️

I will be taking my boat from Canvey up the Thames to the river lea and will be traveling up to Hertford, my air draft is 7" 6

Hello all I will be fitting my Morco heater in the week, I will order the three way valve that was recommended in a previous post to prevent hot water from the calorifier being fed to the Morco Would someone be kind enough to explain where I fit the three way valve in relation to the Morco please ???

Thanks I've been on n off of Canvey for years, my new boat is a 45x 9 nb and will be arriving this morning Thanks all for your advice Gary

Hello all I hope to be taking my boat up the Thames from Canvey to the river lea in the next month or so, it currently has a fixed "wheelhouse" and I have just measured the air draft at 7" 6 I have checked online for bridge heights, but have found conflicting answers . Would anyone have accurate minimum heights